Home > News > Content
Surface Grading Of Stainless Steel Products
Nov 01, 2017

Stainless Steel products are very many, not only have kitchen supplies, but also can be made into furniture, there are some handicrafts, etc., in short, more types. Under huge demand, stainless steel processing plants are now much more. In the process of processing, the level of stainless steel surface processing is not the same, this and the production of products have a close relationship, the following look at the specific surface of stainless steel products is how the classification of the situation.

Stainless Steel processing plant

Original face: NO. 1 The surface of heat treatment and pickling treatment after hot rolling. Generally used in cold-rolled materials, industrial tanks, chemical industry, such as equipment, thicker than 2.0mm-8.0MM. Stainless steel processing plant also has fog surface, No. 2B after cold rolling after heat treatment, pickling, and then finishing finishing to make the surface a moderate light. Because the surface is smooth, easy to grind again, make the surface more bright, use a wide range, such as tableware, building materials and so on. After surface treatment with improved mechanical properties, almost all uses are satisfied.

Blunt surface: NO. 2D cold rolled after heat treatment, pickling, the material is soft, the surface is silver-white luster for deep stamping processing, such as automotive components, water pipes. Coarse sand No. 3 the product which grinds out with 100-120 #. With a better gloss, with discontinuous coarse lines. Used in building interior and exterior decorative materials, electrical products and kitchen equipment. Fine sand is also a stainless steel processing plant often produces the surface processing grade products.

Stainless Steel processing plant

Stainless steel processing plant produced by the surface level of stainless steel products in addition to the above division, there are many other. Bright face is a special kind of surface brightness, can be used directly for the production of mirrors, or other decorative products, beautiful and generous, but also to maintain the brightness for a long time, do not worry about the occurrence of corrosion. The specific choice of what kind of surface processing level, but also according to the characteristics of products to choose to use, as far as possible beautiful and practical.